On the ink selection and printing production of re

2022-08-24
  • Detail

Talking about the ink selection and printing production of reflective film logo

reflective film came out relatively early. Reflective signs are installed on many roads and railways, which has a good effect and greatly eliminates potential safety hazards. At first, reflective film signs were only applied in more important areas due to price reasons. With the development of technology and fierce competition, the price of reflective signs gradually decreased. Now reflective film signs are installed in many places

the manufacturing technology of reflective film logo is more difficult than that of ordinary logo. Generally, engineering grade reflective film is used to make logo, so it is necessary to consider the solvent resistance of reflective film, the drying time of ink, the reflective effect after printing pattern, etc

I. selection of ink: ordinary color ink printing pattern is selected, and the reflective effect of the reflective logo produced is poor, because the pigment contained in the ink is none, which is more different from the fire source machine pigment, and has opacity. Although the color is bright, it covers the reflective effect; Using purchased reflective ink for printing, the produced pattern has good reflective effect, and all aspects of performance meet the use requirements. However, due to the small amount of reflective ink, more colors are required, and sometimes colors need to be mixed, it is necessary to purchase various reflective inks for storage, resulting in capital backlog and high cost. The method of self-made reflective ink can be prepared according to the amount of ink, which will not cause a large amount of residual ink. If it is invalid, please adjust the line of the limit switch (usually installed near the mobile test bench and the fixed beam) to the normal state, and the price will be lower than the purchased ink

second, the production of reflective film logo: first of all, we should prepare reflective ink. Choose an ink with good transparency, which will not reduce the reflective effect and is easy to color. At the same time, the ink should be self drying. In terms of force measurement, the electronic universal testing machine adopts load sensor or low-temperature drying, and the drying time should be controlled below 30mm to prevent the reflective film from being bitten by the solvent; Transparent organic dyes should be selected to make the reflective film give full play to the reflective effect. Organic dyes should be used to meet their own needs and even the needs of the world. Transparent dyes should be mixed into mother liquor first. The solvent can be xylene, and the concentration should be selected according to the instructions of the supplier. Choose and match the colors according to the customer's requirements, add the prepared mother liquor to the transparent ink, and determine the amount after a small test to avoid waste. The adhesive degree of the ink should be appropriate. Generally, the viscosity of the ink is lower than that of the ink for printing other hard marks, so as to avoid sticking to the plate, but the viscosity should not be too small, otherwise it will cause the phenomenon of plate pasting and cannot meet the printing requirements of high-precision patterns. The printing of reflective film is not related to ordinary substrate. It can be dried naturally or at low temperature after printing

Copyright © 2011 JIN SHI